Rivera Knucklehead Reverb KR 100 T Průvodce řešením problémů stáhnout pdf (Strana 27)

Knucklehead Reverb 1.0 p 27

Running two amps in parallel without a Y-cord

INPUTS

FROM

GUITAR

HIGH

GAIN

LOW

GAIN

INPUTS

HIGH

GAIN

LOW

GAIN

The Preamp and output amp sections, as well as all controls, function normally in this

setup. Use a shielded cord. Note: Make sure that at least one speaker cabinet is

connected to both amps unless you desire to use the Preamp sections only, in which

case leave the Standby switch in the “Off” position.

Slaving a Second Amp

RETURNSEND

SEND

LEVEL

Z OUT

560 Ω

Z IN

250K Ω

EFFECTS LOOP

RETURNSEND

Z OUT

560 Ω

Z IN

250K Ω

RETURN

LEVEL

LOOP BLEND

PUSH LOOP

EFFECTS LOOP

Using a shielded cord, connect the first amp's Effects Loop Send to the Effects Loop

Return jack on a second . Adjusting the Send Level of the first amp will affect the

second amp. Try starting with a Send Level of “6”. Return Level of the second amp sets

the relative volume of the second amp. Loop Blend on the second amp should be set to

10. All tone and distortion adjustments are made by the first amp. Note: Make sure

that at least one speaker cabinet is connected to each amp at all times unless you

desire to use the Preamp sections only, in which case leave the Standby switch in the

“Off” position.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Komentáře k této Příručce

Žádné komentáře

Rivera Knucklehead Reverb KR 100 T Průvodce řešením problémů Strana 27

Komentáře k této Příručce

Související produkty a manuály pro Audio zesilovače Rivera Knucklehead Reverb KR 100 T