Rivera Knucklehead Reverb KR 100 T Průvodce řešením problémů stáhnout pdf (Strana 28)

Knucklehead Reverb 1.0 p 28

Other approaches:

If you are using the Effects Loop for effects, try the Sub Output.

If you are also using a subwoofer, try the Recording Output

If the second amp is a separate power amp or has power amp inputs, you can use them

instead of the Effects Return.

Placing a signal processor in the effects loop

RETURNSEND

SEND

LEVEL

Z OUT

560 Ω

Z IN

250K Ω

RETURN

LEVEL

INPUT

OUTPUT

LOOP BLEND

PUSH LOOP

EFFECTS LOOP

Using shielded cords, connect the Effects Loop Send to the processor's input, and the

processor's output to the Effects Loop Return. Adjust the mixture of effect/non-effect

sounds at the signal processor, and set the levels at the amp and processor for lowest

distortion. If you use multiple signal processors, connect them in series (processor 1's

output to processor 2's input, etc.), and patch the 's Send to the first processor's input

and the 's Return to the last processor's output. With the Loop Blend control, you can

adjust your effects devices for 100% wet signal, then adjust the Blend control for the

desired amount of effects to mix with the Knucklehead Reverb’s [dry] signal . This

"Parallel" feature allows the least amount of amplifier signal deterioration potentially

caused by the effects signal chain. If the Blend control is set for 100% Loop ('10'), the

loop can now be considered "Serial".

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Žádné komentáře

Rivera Knucklehead Reverb KR 100 T Průvodce řešením problémů Strana 28